R&S PB Install. Instruction CMU-U61 FLOPPY DISKDRIVE Bi/1CMK 06.05.99 1100.5568.00 02.00
page 9 of 9
4 Functional Test of Option CMU-U61
½ Connect unit to AC supply and switch on.
Enter Floppy Disk Drive into BIOS setup
If PCMCIA Interface is retrofitted on Floppy Disk Drive CMU-U61 or Floppy Disk Drive CMU-U61 is fitted for the
first time the following alterations are necessary in BIOS setup:
½ Connect external keyboard to the keyboard connector on the rear panel of CMU.
½ Switch CMU off and on.
½ Press delete key on external keyboard to enter BIOS setup.
½ Select "Setup Standard" with cursor keys and confirm with enter.
½ Select "Floppy A" with cursor keys and confirm with enter.
½ Select "1.44MB 3.5" with cursor keys and confirm with enter.
½ Press ESC twice to leave BIOS setup and confirm with enter. CMU starts automatically again.
Test of Option Detect
½ Press SETUP hardkey in SYSTEM panel.
½ Press OPTIONS softkey located on the row of keys at bottom of display.
--> Check whether option CMU-U61 is displayed and active.
Test of Option
½ Press the key combination ALT and F4 on the external keyboard to enter DOS mode.
½ Insert disk into floppy disk drive option and enter A: on external keyboard.
½ Check whether disk is detected and can be read.
To Next Page
Loading...
Need help?
General
