Instrument Functions
NRP2
125User Manual 1173.9140.02 ─ 07
4.5.5.1 Controls in Marker display mode
Display
Selects another view, see chapter 4.5.2, "Trace window", on page 114
.
Config Marker...
Opens the subdialog to manually define the marker positions, see chapter 4.5.5.2,
"Marker diagram settings", on page 125.
Pos Scale
Defines if the cursor keys position or scale the waveform.
"Pos"
The cursor keys shift the waveform in horizontal and vertical direction
"Scale"
The cursor keys expand and compress the waveform. When the hori-
zontal scaling is modified, the points (pixels) at the left of the screen
remain unchanged. When the vertical scaling is modified, the neutral
zone depends on the unit selected: the points in the center of the
screen remain unchanged when dBm, dB and dBµV are used. The
points at the bottom of the screen remain unchanged in all other dis-
plays.
▼ / ▲
Defines the active marker which can be positioned by means of the cursor keys.
(Max/Min marker position)
Sets the two markers to the extreme values of the selected trace each time the key is
pressed. If two traces are active, pressing the left side of the softkey selects trace 1
and pressing the right side selcets trace 2.
Trace Func...
Opens the "Trace Function" dialog box, see chapter 4.5.3.4, "Trace function settings",
on page
119 .
4.5.5.2
Marker diagram settings
► Open the "Marker Config" dialog box open via the Window→Graph→"Dis-
play"→"Marker" control panel ("Trace&Statistics" sensor mode).
Displaying traces
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
