Messages and alarms R&S NRP
1144.1400.12 4.66 E-2
Resolution reduced in the Scope mode
The settings require a sampling rate located out-
side the range supported by the sensor. Thus, the
number of sampled points is temporarily reduced.
Hardware error
A sensor has detected a hardware error.
Automatic window initialization
If an additional sensor is connected to the
R&S NRP during operation and if no currently
open window displays the values measured in the
channel concerned, the R&S NRP automatically
offers to open a window and to configure it for
measurements with the additional sensor con-
nected.
The previous settings of the newly opened window
are lost. To prevent this, we recommend you to
cancel with the (ESC) key and to manually config-
ure a window.
To Next Page
Loading...
