R&S NRP SCPI Error Messages
1144.1400.12 9.3 E-2
Error code Error text returned upon queue query
Explanations
-171 Invalid expression
The command contains an invalid mathematical expression data element.
-178 Expression data not allowed
The command contains mathematical expression data at a point where they are not allowed.
Execution Error
Execution errors; cause bit 4 in the ESR register to be set
Error code Error text returned upon queue query
Explanations
-200 Execution error
An error occurred upon command execution.
-203 Command protected
An attempt was made to execute a protected command.
-210 Trigger error
Error on triggering the device.
-211 Trigger ignored
A *TRG or a triggering signal was ignored.
-213 Init ignored
A request for a measurement initialization was ignored as another measurement was already in progress.
-214 Trigger deadlock
A measurement could not be started or a result query could not be processed since the device would otherwise
enter a deadlock state. This occurs under the following conditions:
(1) TRIG:SOUR BUS;:INIT;:FETCh?: A *TRG or TRIG:IMM would be required for triggering but these
commands cannot be executed since FETCh? blocks the entry. But FETCh? waits until the measured values are
available.
(2) FETCh? was called but no valid result was available and the trigger system of the sensor is IDLE. FETCh?
blocks the entry so that a measurement cannot be started with INIT either.
-220 Parameter error
The command contains a faulty or invalid parameter.
-221 Settings conflict
There is a setting conflict between two or more parameters.
-222 Data out of range
A program data element is outside the legal range as defined by the device.
-223 Too much data
A valid parameter is received but it contains more data than the device can handle.
-224 Illegal parameter value
The parameter value is invalid.
To Next Page
Loading...
