Remote Control - Commands R&S NRP
1144.1400.12 6.128 E-3
Standard Configurations
The following tables list the settings that can be made when configuring the R&S NRP with the
SYST:STAN:PRE <string> remote control command. The following values are provided for the
<string> parameter.
• "GSM/EDGE"
• "NADC/UPLINK"
• "NADC/DOWNLINK"
• "PDC/UPLINK"
• "PDC/DOWNLINK"
• "DECT"
• "WCDMA/3GPP FDD"
• "WCDMA/3GPP TDD DL"
• "WCDMA/3GPP TDD UL"
• "TD-SCDMA"
• "Bluetooth DH1"
• "Bluetooth DH3"
• "Bluetooth DH5"
• "CDMA2000"
Note: The tables list only the sensor parameters. If
SYSTem:STANdard:PWSettings OFF is set, the calculate blocks
(CALCulate:...), the window system (DISPlay:...) and the output unit
(UNIT:...) are also configured.
To Next Page
Loading...
