Rohde & Schwarz R&S NRP - Contrast and Brightness (Contrast;Brightness)

Hardkeys R&S NRP
1144.1400.12 4.6 E-2
Zero/Cal dialog box
Config… – ( )
ä
Fig. 4-7 Config Test dialog box
A | B | C | D – ( )
ä↔ä
Tabs for selecting the measurement channel. When the dialog box
opens, it shows the data of the sensor last tested.
Test Limits – ( )
Sensor ä ä
Tolerance limits for sensors without a lead-in attenuator or with an
attenuator that has been removed.
Test Limits – ( )
Sensor & Pad ä ä
Tolerance limits for sensors with a lead-in attenuator.
Set to defaults – ( )
ä
Resets the factory default settings.
Settings locked – ( )
ä
Protects the settings against being changed by mistake.
Contrast and brightness
Hardkey
( Æ )
ä
Fig. 4-8 Display dialog box
Contrast – ( )
ä ä
Sets the display contrast.
Brightness –
( )
ä ä
Sets the display brightness.
Remote Control
DISPlay:ILLumination[?] ON | OFF
( Æ )