Measuring average power (Cont Av mode) R&S NRP
1144.1400.12 2.2 E-2
Measuring average power (Cont Av mode)
1 Set the R&S NRP to the PRESET state.
The instrument is set to a well-defined initial state to prevent any previous settings from causing incor-
rect results.
¾ Put the R&S NRP into operation as described in
Chapter 1 and connect a sensor to connector A.
({PRE}SET)
*
¾ Press the ({PRE}SET) key.
The File menu appears.
The appearance of Preset on a black background
means that this function can also be started by pressing
the ({PRE}SET) key again.
({PRE}SET)
*
¾ Press the ({PRE}SET) key again or the
Preset softkey.
The Setup dialog box disappears and the meter is in the
preset state.
A display window indicates the result (in dBm) obtained
with sensor A.
To Next Page
Loading...
