Rohde & Schwarz R&S NRP - Default Chapter; Fig

R&S NRP List of Figs. and Tables Chapter 6
1144.1400.12 I-6.3 E-3
Figs.
Fig. 6-1: Overview of SCPI command systems and their mutual interaction ..........................................6.9
Fig. 6-2: SENSe system ........................................................................................................................6.10
Fig. 6-3: Command system CALCulate.................................................................................................6.10
Fig. 6-4: Relationship between the commands CONFigure, READ?, FETCh? and MEASure? ...........6.12
Fig. 6-5: Characteristic of analog outputs..............................................................................................6.45
Fig. 6-6: Voltage at TTL output..............................................................................................................6.49
Fig. 6-7: Meaning of drop-out TOLerance.............................................................................................6.58
Fig. 6-8: Timing parameters for the Timegate mode.............................................................................6.59
Fig. 6-9: Effect of commands SENS[1..4]:TIM:EXCL:STAR and :STOP ........................................6.65
Fig. 6-10: Standard SCPI status register...............................................................................................6.70
Fig. 6-11: Overview on structure of Status Reporting System ..............................................................6.73
Fig. 6-12: Operation Status Register.....................................................................................................6.74
Fig. 6-13: Questionable Status Register ...............................................................................................6.75
Fig. 6-14: Pin assignment of IEC/IEEE-bus interface..........................................................................6.124
Tables
Table 6-1: High-level measurement commands....................................................................................6.14
Table 6-2: Commands of the CALCulate system..................................................................................6.21
Table 6-3: Output unit of measured value of calculate block. ...............................................................6.27
Table 6-4: Commands of the CALibration system.................................................................................6.29
Table 6-5: Commands of the DISPlay system ......................................................................................6.30
Table 6-6: Commands of the FORMat command system.....................................................................6.38
Table 6-7: Commands of the MEMory system......................................................................................6.39
Table 6-8: Commands of the OUTPut system ......................................................................................6.44
Table 6-9: Voltage at TTL output...........................................................................................................6.49
Table 6-10: Commands of the SENSe system......................................................................................6.50
Table 6-11: Measurement modes..........................................................................................................6.56
Table 6-12: Commands of the SERVice command system..................................................................6.66
Table 6-13: Queries for status registers................................................................................................6.69
Table 6-14: Commands for the configuration of status registers ..........................................................6.69
Table 6-15: Decimal value of individual bits in the SCPI status register...............................................6.71
Table 6-16: Meaning of bits used in the status byte..............................................................................6.76
Table 6-17: Meaning of bits used in the Device Status Register ..........................................................6.77
Table 6-18: Meaning of bits used in the Questionable Status Register ................................................6.78
Table 6-19: Meaning of bits used in the Standard Event Status Register ............................................6.79