List of Figs. and Tables Chapter 6 R&S NRP
1144.1400.12 I-6.4 E-3
Table 6-20: Meaning of bits used in the Operation Status Register......................................................6.80
Table 6-21: Meaning of bits used in the Operation Calibrating Status Register ...................................6.81
Table 6-22: Meaning of bits used in the Operation Measuring Status Register....................................6.82
Table 6-23: Meaning of bits used in the Operation Status Register......................................................6.83
Table 6-24: Meaning of bits used in the Operation Sense Status Register ..........................................6.84
Table 6-25: Meaning of bits used in the Operation Lower Limit Fail Status Register ...........................6.85
Table 6-26: Meaning of bits used in the Operation Upper Limit Fail Status Register...........................6.86
Table 6-27: Meaning of bits used in the Questionable Power Status Register.....................................6.87
Table 6-28: Meaning of bits used in the Questionable Window Status Register ..................................6.88
Table 6-29 Meaning of bits used in the Questionable Calibration Status Register...............................6.89
Table 6-30: Initialization of device status ..............................................................................................6.92
Table 6-31: Commands of the SENSe system......................................................................................6.93
Table 6-32: Valid parameter values for the SYSTem:KEY command. ................................................6.96
Table 6-33: Preset and *RST value.......................................................................................................6.98
Table 6-34: Commands for setting the trigger system of a sensor .....................................................6.103
Table 6-35: Commands of the UNIT system.......................................................................................6.108
Table 6-36: Compatibility information about remote control commands.............................................6.122
Table 6-37: Interface functions of IEC/IEEE bus.................................................................................6.126
Table 6-38: Common commands ........................................................................................................6.127
Table 6-39: Addressed commands .....................................................................................................6.127
To Next Page
Loading...
