Rohde & Schwarz R&S NRP - Pre 0; PRE? - Parallel Poll Enable Register Query; PSC 0|1 - Power on Status Clear Command; PSC? - Power on Status Clear Query

R&S NRP Remote Control - Commands
1144.1400.12 6.7 E-3
*PRE 0..255 - Parallel Poll Enable Register Command
Sets the Parallel Poll Enable Register to the defined value.
*PRE? - Parallel Poll Enable Register Query
Returns the current content of the Parallel Poll Enable Register.
*PSC 0|1 - Power On Status Clear Command
Determines whether the content of the ENABle registers is retained or cleared upon power-up.
*PSC 0
causes the status registers to retain their content. With appropriate configuration of the ESE
and SRE status registers, a service request may be triggered upon power-up.
*PSC 1
clears the registers.
*PSC? - Power On Status Clear Query
The query *PSC? reads out the content of the power-on-status-clear flag. The response can be "0" or
"1" .
*RCL 0..19 - Recall
Calls the device state which has been stored with the *SAV command under the indicated number. The
effect of
*RCL 0 to 19 is the same as if one of the setups 0 to 19 had been selected in manual control.
*RCL
0 resets the device to the default state.
*RST - Reset
Sets the device to the defined default state and has almost the same effect as the SCPI command
SYSTem:PRESet. (Table 6-33). The table also provides default settings. The following table documents
the difference. SYST:PRES acts like the frontpanel key (PRES).
INITiate:CONTinuous SENSe:AVERage:TCONtrol
*RST
OFF REPeat
SYSTem:PRESet
ON MOVing
*SAV 1..19 - Save
Stores the current device state under the indicated number.