Rohde & Schwarz R&S NRP - I Programming Measurements with the R&S Nrp

R&S NRP Table of Contents Annex Chapter I
1144.1400.12 I-Annex.1 E-2
Table of Contents
I Programming Measurements with the R&S NRP.......................................................... I.1
Measuring with high-level commands............................................................................................ I.1
The simplest measurement............................................................................................. I.1
Relative measurements .................................................................................................. I.2
Processing the results of two sensors............................................................................. I.3
Selecting a measurement mode ..................................................................................... I.4
Selecting the output unit for measured values................................................................ I.6
Division of MEAS?........................................................................................................... I.7
Trigger state system......................................................................................................................... I.9
Logic relationship of command systems SENSe, CALCulate and UNIT .................................. I.11
Measuring with low-level commands ........................................................................................... I.12
The simplest measurement........................................................................................... I.12
Configuration of the trigger system ............................................................................... I.12
Configuration of sensor settings.................................................................................... I.16
Configuration of CALCulate blocks ............................................................................... I.20
Optimization of measurement speed............................................................................................ I.21