Rohde & Schwarz R&S NRP

To Next Page

To Previous Page

R&S NRP Remote Control - Commands

1144.1400.12 6.13 E-3

Syntactical Structure of High-Level Measurement Commands

The high-level measurement commands can be divided as follows:

<head>

CONFigure[1..8], READ[1..8], MEASure[1..8], FETCh[1..8]

Selection of one of the measurement modes ContAv, ContAv with data

buffering, Burst, Timeslot or Scope. (ÆSENSe[1..4]:FUNCtion command

on page 6.56).

Keywords:

• [:SCALar][:POWer][:AVG]

• [:SCALar][:POWer]:TSLot

• [:SCALar][:POWer]:BURSt

• :ARRay[:POWer][:AVG]

• :XTIMe[:POWer]

Specification of a calculation function for the addressed CALCulate block (Æ

CALCulate[1..8]:MATH:EXPRession command on page 6.26).

If <expression> is not specified, the measured value of the primary channel

is output.

Keywords:

• :RELative

• :DIFFerence

• :DIFFerence:RELative

• :SUM

• :SUM:RELative

• :RATio

• :RATio:RELative

• :RLOSs

• :SWR

• :REFLection

[?]

Queries must be terminated with an "?".

<parameter_list>

A list with parameters whose meaning is determined by the selected

<function>.

Since all four high-level measurement commands use the same parameter lists, they are described

together in this section.

Rohde & Schwarz R&S NRP - Page 188