Rohde & Schwarz R&S NRP - Page 190

R&S NRP Remote Control - Commands
1144.1400.12 6.15 E-3
ContAv mode (with data buffering)
CONFigure[1..8]
:ARRay
[:POWer]
[:AVG]
READ[1..8] | MEASure[1..8] |
FETCh[1..8]
:ARRay
[:POWer]
[:AVG]?
<buffered_parameter_list>
:RELative :RELative? <buffered_parameter_list>
:DIFFerence :DIFFerence? <buffered_parameter_list>
:RELative :RELative? <buffered_parameter_list>
:SUM :DIFFerence? <buffered_parameter_list>
:RELative :RELative? <buffered_parameter_list>
:RATio :RATio? <buffered_parameter_list>
:RATio:RELative :RATio:RELative? <buffered_parameter_list>
:SWR :SWR? <buffered_parameter_list>
:REFLection :REFLection? <buffered_parameter_list>
:RLOSs :RLOSs? <buffered_parameter_list>
Scope mode
CONFigure[1..8] READ[1..8] | MEASure[1..8] |
FETCh[1..8]
:XTIMe :XTIMe
[:POWer] [:POWer]? <scope_parameter_list>