R&S NRP Remote Control - Commands
1144.1400.12 6.63 E-3
[SENSe[1..4]]:TRACe:AVERage:COUNt:AUTO:TYPE[?] RESolution | NSR
Selects a method for the Scope mode by which the automatic filter length switchover can operate:
SENS[1..4]:AVER:COUN:AUTO:TYPE
Setting taken into account
RESolution SENS[1..4]:AVER:COUN:AUTO:RES
NSR
SENS[1..4]:AVER:COUN:AUTO:NSR
SENS[1..4]:AVER:COUN:AUTO:MTIM
*RST value: depending on sensor
[SENSe[1..4]]:TRACe:AVERage:TCONtrol[?] MOVing | REPeat
As soon as a new single value is determined, the filter window is advanced by one value so that the
new value is taken into account by the filter and the oldest value is forgotten.
[SENSe[1..4]]:AVERage:TCONtrol (terminal control) then determines in the Scope mode whether
a new result will be calculated immediately after a new measured value is available (
MOVing) or only
after an entire range of new values is available for the filter (
REPeat).
*RST-Wert: (PRES) and SYST:PRES: MOV
*RST: REP
[SENSe[1..4]]:TRACe:OFFSet:TIME[?] <float_value>
This command determines the relative position of the trigger event in relation to the beginning of the
Scope measurement sequence.
Unit: S
Value range: depending on sensor
*RST value: depending on sensor
[SENSe[1..4]]:TRACe:POINts <int_value>
Sets the number of desired values per Scope sequence.
Unit: -
Value range: depending on sensor
*RST value: depending on sensor
Error messages:
28
"Sensor not idle": The sensor is not in the IDLE state.
To Next Page
Loading...
