R&S NRP Graphically representing power versus time (Scope mode)
1144.1400.12 2.19 E-2
Close | Expand – ( )
*
The window is now in the Scope display mode and shows
the Trace page. The
Max and Min fields are used to
choose the level range (the vertical resolution), and the
Length field to choose the horizontal resolution.
If you do not see a trace, the trigger threshold probably
does not match the signal. In this case, a ? symbol on
a black background (see step
o) will apear in the row of
warning symbols below the window title bar.
The other pages that can be selected via the tabs are
used to configure the parameters of the Timeslot mode
(T'slots, ) Measuring average power in defined time
interval) as well as to set gates (Gates) by using markers
and to perform measurements within these gates (Meas).
To Next Page
Loading...
