Rohde & Schwarz R&S ZNB - Page 1306

Command Reference
R&S
®
ZNB/ZNBT
1306User Manual 1173.9163.02 ─ 53
consists of TTL pulses of configurable duration and polarity which can be sent before
or after each sweep or measurement point.
Figure 8-1: Output trigger signal at EXT TRIG OUT
TRIGger:CHANnel<Ch>:AUXiliary<n>[:ENABle]..............................................................1306
TRIGger:CHANnel<Ch>:AUXiliary<n>:DURation.............................................................1306
TRIGger:CHANnel<Ch>:AUXiliary<n>:INTerval...............................................................1307
TRIGger:CHANnel<Ch>:AUXiliary<n>:OPOLarity............................................................1307
TRIGger:CHANnel<Ch>:AUXiliary<n>:POSition.............................................................. 1308
TRIGger:CHANnel<Ch>:AUXiliary<n>[:ENABle] <EnableTriggOut>
Turns the external trigger output EXT TRIG OUT for channel no. <Ch> on or off.
Suffix:
<Ch>
.
Channel number
<n> Auxiliary channel number. This suffix is ignored; it can be set to
1 or omitted.
Parameters:
<EnableTriggOut> Turn trigger output on (ON) or off (OFF, no signal).
*RST: OFF
Example:
TRIGger:CHANnel:AUXiliary:ENABle ON
Turn on the trigger output for channel no. 1 (channel suffix omit-
ted).
TRIGger:CHANnel:AUXiliary:DURation 10 us
Change the width of the output trigger pulses.
TRIGger:CHANnel:AUXiliary:POSition BEFore
Send the output trigger pulses before data acquisition starts.
TRIGger:CHANnel:AUXiliary:INTerval SWEep
Send one output trigger pulse per sweep.
TRIGger:CHANnel:AUXiliary:OPOLarity POSitive
Select positive polarity for the output trigger pulses.
TRIGger:CHANnel<Ch>:AUXiliary<n>:DURation <TrigOutDuration>
Specifies the width of the output trigger pulses at EXT TRIG OUT.
SCPI Command Reference