Roland AE-30 - Scene;Chorus; Chorus Parameters

28
Scene Parameters
SCENE/CHORUS
Parameter Value Explanation
CH SW OFF, ON Turns the chorus on/o.
Chorus Type
Selects the chorus type.
OFF, 1 Chorus, 2 CE-1, 3 SDD-320, 4 JUNO-106 Chorus
FX
Chorus parameters
Congure the parameters of the selected chorus type.
See “Chorus parameters”
The available parameters dier depending on the type of chorus you selected in
Chorus Type.
OUTPUT
Chorus Level 0–127
Sets the amount of chorus.
If you don’t want to add the chorus eect, set it to 0.
Reverb Send Level 0–127
Sets the amount of reverb.
If you don’t want to add the reverb eect, set it to 0.
Chorus Parameters
1 Chorus
This is a stereo chorus.
Parameter Value Explanation
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Feedback 0–127
Level at which chorus sound is
returned to the input
2 CE-1 (Chorus)
This models the classic BOSS CE-1 chorus eect unit. It provides a
chorus sound with a distinctively analog warmth.
Parameter Value Explanation
Intensity 0–127 Chorus depth
3 SDD-320 (Dimension D)
This models Roland’s DIMENSION D (SDD-320). It provides a clear
chorus sound.
Parameter Value Explanation
Mode
1, 2, 3, 4, 1+4,
2+4, 3+4
Switches the mode.
4 JUNO-106 Chorus
This models the chorus eects of the Roland JUNO-106.
Parameter Value Explanation
Mode
I, II, I+II, JX I,
JX II
Type of Chorus
I+II: The state when two buttons
are pressed simultaneously.
Noise Level 0–127
Amount of noise produced by
the chorus