Roland AE-30 - Tone;Partial;Partial Eq; Tone;Partial;Output; Tone;Partial;Control

47
Tone Parameters
TONE/PARTIAL/PARTIAL EQ
Parameter Value Explanation
Switch OFF, ON Turns the equalizer on/o for each partial.
Low Gain -24.0–+24.0 (dB) Gain of the low range.
Low Frequency 20–16000 (Hz) Frequency of the low range.
Mid Gain -24.0–+24.0 (dB) Gain of the middle range.
Mid Frequency 20–16000 (Hz) Frequency of the middle range.
Mid Q 0.5–16.0 (0.1step)
Width of the middle range.
Set a higher value to narrow the range to
be aected.
High Gain -24.0–+24.0 (dB) Gain of the high range
High Frequency 20–16000 (Hz) Frequency of the high range.
TONE/PARTIAL/OUTPUT
Parameter Value Explanation
Output Assign DRY, MFX
Species how the sound of each partial
will be output.
Chorus Send Level 0–127
Species the level of the signal sent to the
chorus for each partial.
Reverb Send Level 0–127
Species the level of the signal sent to the
reverb for each partial.
TONE/PARTIAL/CONTROL
Parameter Value Explanation
ADSR Envelope
Switch
OFF, ON
This imitates the operation of the ADSR
envelope that is provided on an analog
synthesizer.
* If ADSR Envelope Switch is “ON,”
the “Time 2” parameters of Pitch/
Filter/Amp Env Time respectively
are ignored, and only the “Level 3”
parameters of Pitch/Filter/Amp Env
Level are valid.
Envelope Mode
Species the envelope mode.
NO-SUS
The envelope transitions to the release
segment after passing Time 3 regardless
of the note-o timing, operating
according to the times specied by the
envelope.
SUSTAIN
The Envelope Level 3 is held from when
the envelope Time 3 has elapsed until
note-o.
When note-o occurs, the envelope
transitions from the current value to the
Time 4 segment (release segment).
Damper Free Note OFF, 1–127
For notes above the specied note
number, the Envelope Mode operates as
“NO-SUS.”
Use this to simulate the undamped
region of a piano sound.
D.Free Decay
Oset
-100–+100
Species a ne adjustment to the time
over which the sound decays when the
Damper Free Note eect is applied.
Receive Bender OFF, ON
Species for each partial whether MIDI
pitch bend messages are received (ON)
or not received (OFF).
Receive
Expression
OFF, ON
Species for each partial whether MIDI
expression messages are received (ON)
or not received (OFF).
Receive Hold-1 OFF, ON
Species for each partial whether MIDI
hold 1 messages are received (ON) or not
received (OFF).
Redamper Switch OFF, ON
If Redamper Switch is ON, you can
perform the Half Damper operations
used for piano sounds.
However, the following conditions
must be satised in order to use this
operation.
5 Envelope Mode is NO-SUS
5 Amp Envelope’s Level 1 and 2 are 1 or
greater
5 Amp Envelope’s Times are Time 3 > Time4
Soft EQ Sens 0–100
Increases the proportion by which the
EQ’s HighGain is lowered by the amount
of pedal.
With a setting of “0,” this has no eect.
Wave Tempo Sync
OFF, ON
Turn this on to match the phrase loop
with the clock (tempo).
* This is enabled with when you select
a waveform for which a tempo (BPM)
is shown.