Roland AE-30 Parameter Guide

12
Settings Used on this Instrument
Assigning a switch-type controller (S1_1–Ta_2)
* Indications of “***” in the table will contain the following names.
S1_1–2, S2_1–2, X_1–2, C1_1–2, C2_1–2, C3_1–2, C4_1–2, C5_1–2, Tc_1–2, Ta_1–2
* For controllers whose Func parameter is “O,” their parameters related to the assign settings are not shown.
Indication (Parameter)
Value Explanation
*** Func See “Assign Function List” Species the function that is assigned when each controller is pressed.
*** Release Val
0–127
Specify the value when you take your nger o the button (Release) and the value
when you press the button (Press).
*** Press Val
*** Mode
Species the operation mode.
Latch
Each time you press the button, the Press Value and Release Value alternate.
Momentary
The Press Value is applied while the button is pressed, and the Release Value is applied
while the button is released.
Assign Function List
Value Range Explanation Remarks
O
No function is assigned.
CC 01–31, CC33–95 0–127 Control change
Bend Down 0–127 Bend down
Bend Up 0–127 Bend up
After Touch 0–127 After touch (Channel Key Pressure)
Scene Down --- Select previous scene
Not available for breath or bite
control
Scene Up --- Select next scene
Favorite Down --- Select the previous favorite scene
Favorite Up --- Select the next favorite scene
Chorus Sw O, On Turns the chorus on.
Reverb Sw O, On Turns the reverb on.
Delay Sw O, On Turns the delay on.
IFX Sw O, On Turns the IFX on.
Unison Sw O, On Turns unison on.
Oct Down --- Octave down
Oct Up --- Octave up
Transpose Down ---
Transpose down (0
&
-1
&
... -5
&
+6 ... )
Transpose Up ---
Transpose up (0
&
+1
&
... +6
&
-5 ... )
Drone Sw O, On Turns the drone function on.
Harmony Sw O, On Turns the harmony on.
X-Fade 0–127 Crossfade
MIDI Parameters
You can assign a MIDI control function to each controller, and specify how control occurs.
Maximum no. of assignable functions per controller
Breath 8
Bite, Thumb Pad 4
Lever Up/Down 2
Motion 2
S1, S2, Side Key 2
* As with Assign, the MIDI control parameters work when the settings in “Asgn Src” (assign source) of each controller of the system are set to
“System.”
If Asgn Src is set to “Scene,” each scene’s MIDI control settings are used (p. 5).

Roland AE-30 Specifications

General

Brand	Roland
Model	AE-30
Category	Recording Equipment
Language	English