Roland AE-30 - Step Flanger; Hexa-Chorus

55
MFX/IFX Parameters
25 Step Flanger
This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms
of a note-value of a specified tempo.
R out
L out
2-Band EQ
2-Band EQ
Balance W
Balance W
Feedback
Feedback
Balance D
Balance D
L in
Step
Flanger
Step
Flanger
R in
Parameter Value Explanation
Filter Type OFF, LPF, HPF
Type of filter
OFF: No filter is used.
LPF: Cuts the frequency range above the
Cutoff Freq
HPF: Cuts the frequency range below the
Cutoff Freq
Cutoff Freq
200, 250, 315, 400,
500, 630, 800, 1000,
1250, 1600, 2000,
2500, 3150, 4000,
5000, 6300, 8000
(Hz)
Basic frequency of the filter
Pre Delay 0.0–100.0 (msec)
Adjusts the delay time from the direct
sound until the flanger sound is heard.
Rate (sync sw) OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Scene Tempo” (p. 22)
Rate (Hz) 0.05–10.00 (Hz)
Frequency of modulation
Rate (note)
Note
& “Note” (p. 64)
Depth 0–127 Depth of modulation
Phase 0–180 (deg) Spatial spread of the sound
Feedback -98–+98 (%)
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the phase.
Step Rate (sync sw) OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Scene Tempo” (p. 22)
Step Rate (Hz) 0.10–20.00 (Hz)
Rate (period) of pitch change
Step Rate (note)
Note
& “Note” (p. 64)
Low Gain -15–+15 (dB) Gain of the low range
High Gain -15–+15 (dB) Gain of the high range
Balance D100:0W–D0:100W
Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0–127 Output Level
26 Hexa-Chorus
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound.
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
Hexa
Chorus
R in
Parameter Value Explanation
Pre Delay 0.0–100 (msec)
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate (sync sw) OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Scene Tempo” (p. 22)
Rate (Hz) 0.05–10.00 (Hz)
Frequency of modulation
Rate (note)
Note
& “Note” (p. 64)
Depth 0–127 Depth of modulation
Pre Delay
Deviation
0–20
Adjusts the differences in Pre Delay
between each chorus sound.
Depth Deviation -20–20
Adjusts the difference in modulation
depth between each chorus sound.
Pan Deviation 0–20
Adjusts the difference in stereo location
between each chorus sound.
0: All chorus sounds will be in the center.
20: Each chorus sound will be spaced at
60 degree intervals relative to the center.
Balance D100:0W–D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level