Roland AE-30 - Tone;Mfx

38
Tone Parameters
Parameter Value Explanation
MFX Switch OFF, ON Switches the MFX on/o.
MFX Type
See “MFX/IFX
Parameters”
(p. 50)
Selects the MFX type.
MFX parameters
Edit the parameters for the selected MFX.
The available parameters dier
depending on the type of the eects you
selected in MFX Type.
SEND
Chorus Send Level 0–127
Adjusts the amount of chorus.
If you don’t want to add the chorus eect,
set it to “0.”
Reverb Send Level 0–127
Adjusts the amount of reverb.
If you don’t want to add the reverb eect,
set it to “0.”
CONTROL
Control Source
1–4
Species the MIDI message that will control the corresponding
MFX CONTROL parameter.
OFF MFX CONTROL will not be used.
CC01–31 Controller number 1–31
CC33–95 Controller number 33–95
BEND Pitch bend
AFTER TOUCH Aftertouch
SYS-CTRL1–4
Use the controller that is assigned by the
System Control Source 1–4.
Control
Destination 1–4
Species the multi-eect parameters that are controlled by
MFX CONTROL.
The multi-eects parameters available for control will depend
on the multi-eects type.
Control Sens 1–4
-63–+63
Species the depth of MFX CONTROL.
Specify a positive (+) value if you want
to change the value of the assigned
destination in a positive direction (larger,
toward the right, faster, etc.), or specify a
negative (-) value if you want to change
the value in a negative direction (smaller,
toward the left, slower, etc.).
Larger values will allow a greater amount
of control.
Controlling a MFX via MIDI (MFX CONTROL)
You can use MIDI messages such as control change messages to
control the principal MFX parameters.
This capability is called “MFX CONTROL (multi-eects control).”
The editable parameters are pre-determined according to the MFX
type. You can specify up to four parameters for multi-eect control.
To use MFX CONTROL, you’ll need to specify which MIDI message
(Source) will aect which parameter (Destination), and how greatly
(Sens).
TONE/MFX