Roland AE-30 - Page 30

30
Scene Parameters
3 Delay
0
Trem (Delay
0
Tremolo)
Tremolo is applied to the delay sound.
Parameter Value Explanation
Input Mode
MONAURAL The input is mono-mixed.
STEREO The sound is input in stereo.
Delay Time
(sync sw)
OFF, ON
If this is “ON,” the delay
synchronizes with the tempo.
Delay Time
(msec)
1–1300
Adjusts the delay time from
the direct sound until the delay
sound is heard.
Delay Time
(note)
Note (*1)
Feedback -98–+98 (%)
Adjusts the proportion of the
delay sound that is fed back into
the eect. Negative (-) settings
will invert the phase.
HF Damp (*2)
Adjusts the frequency above
which the delay sound fed
back to the eect is ltered out
(BYPASS: no cut).
Tremolo Switch OFF, ON Switches the tremolo eect on/o
Tremolo Mod
Wave
Modulation Wave
TRI Triangle wave
SQR Square wave
SIN Sine wave
SAW1
Sawtooth wave
SAW2
TRP Trapezoidal wave
Tremolo Rate
(sync sw)
OFF, ON
If this is “ON,” the tremolo
synchronizes with the tempo.
Tremolo Rate
(Hz)
0.05–10.00 (Hz)
Tremolo rate
Tremolo Rate
(note)
Note (*1)
Tremolo Depth 0–127 Tremolo depth
4 2Tap PanDly (2 Tap Pan Delay)
Delayed sound is heard from the two locations you specify.
Parameter Value Explanation
Delay Time
(sync sw)
OFF, ON
If this is “ON,” the delay
synchronizes with the tempo.
Delay Time
(msec)
1–1300
Adjusts the delay time from the
direct sound until the second
delay sound is heard.
Delay Time
(note)
Note (*1)
Feedback -98–+98 (%)
Adjusts the proportion of the
delay sound that is fed back into
the eect. Negative (-) settings
will invert the phase.
HF Damp (*2)
Adjusts the frequency above
which the delay sound fed
back to the eect is ltered out
(BYPASS: no cut).
Delay 1 Pan L64–63R Stereo location of Delay 1
Delay 2 Pan L64–63R Stereo location of Delay 2
Delay 1 Level 0–127 Volume of Delay 1
Delay 2 Level 0–127 Volume of Delay 2
5 3Tap PanDly (3 Tap Pan Delay)
Delayed sound is heard from the three locations you specify.
Parameter Value Explanation
Delay Time
(sync sw)
OFF, ON
If this is “ON,” the delay
synchronizes with the tempo.
Delay Time
(msec)
1–2600
Adjusts the delay time from the
direct sound until the third delay
sound is heard.
Delay Time
(note)
Note (*1)
Feedback -98–+98 (%)
Adjusts the proportion of the
delay sound that is fed back into
the eect. Negative (-) settings
will invert the phase.
HF Damp (*2)
Adjusts the frequency above
which the delay sound fed
back to the eect is ltered out
(BYPASS: no cut).
Delay 1 Pan L64–63R Stereo location of Delay 1
Delay 2 Pan L64–63R Stereo location of Delay 2
Delay 3 Pan L64–63R Stereo location of Delay 3
Delay 1 Level 0–127 Volume of Delay 1
Delay 2 Level 0–127 Volume of Delay 2
Delay 3 Level 0–127 Volume of Delay 3
(*1) 1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T,
1/8., 1/4, 1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
(*2) 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500,
3150, 4000, 5000, 6300, 8000 (Hz), BYPASS