Roland AE-30 - Page 49

49
Tone Parameters
Parameter Value Explanation
Destination 1–4
PMT
If the Matrix Control is used to split
partials, set the Velocity Control (p. 35)
to “OFF.”
5 If the Matrix Control is used to split
partials, we recommend setting the
Sens to “+63.” Selecting a lower value
may prevent switching of the partials.
Furthermore, if you want to reverse the
eect, set the value to “-63.”
5 If you want to use matrix control to
switch smoothly between partials, use
the Velocity Fade Low and Velocity
Fade Up (p. 40). The higher the
values set, the smoother the switch is
between the partials.
FXM
Changing the depth of frequency
modulation produced by FXM
MFX-CTRL1
Applies a change to MFX CONTROL 1–4
Source.
If this is specied for more than one
partial, the result will be the summed
values.
MFX-CTRL2
MFX-CTRL3
MFX-CTRL4
PW Applies change to PW.
PWM Applies change to PWM.
FAT Applies change to FAT.
XMOD
This setting is valid only for the carrier
partial (Partial 1 or 3), and applies
change to the CROSS MOD 1-2 Depth or
CROSS MOD 3-4 Depth.
LFO1-STEP
Species the step position.
In this case, the Sens value is ignored.
* This is valid when the LFO1/LFO2
Waveform (p. 45) is “STEP.”
LFO2-STEP
SSAW-DETN
Applies change to Super-SAW Detune.
* This is valid when the OSC Type
(p. 39) is “SuperSAW.”
PIT-DEPTH
Changes the depth of the PITCH envelope.
FLT-DEPTH Changes the depth of the FILTER envelope.
AMP-DEPTH Changes the depth of the AMP envelope.
XMOD2
Applies change to XMOD2 1-2 (3-4)
Depth.
* This is valid when the Structure 1-2
(3-4) (p. 36) is “XMOD2.”
ATT Applies change to OSC Attenuator.
RING-OSC1-LEV
Applies change to RING OSC1 Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is “RING.”
RING-OSC2-LEV
Applies change to RING OSC2 Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is “RING.”
XMOD-OSC1-LEV
Applies change to CROSS MOD OSC1
Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is “XMOD” or “XMOD2.”
XMOD-OSC2-LEV
Applies change to CROSS MOD OSC2
Level.
* This is valid when the Structure 1-2
(3-4) (p. 36) is “XMOD” or “XMOD2.”
Sens 1–4
-63–+63
Specify the eective depth of the matrix
controls.
To make an increase in the currently
selected value (to get higher values,
move to the right, increase rates, and so
on), select a positive (+) value; to make
a decrease in the currently selected
value (to get lower values, move to the
left, decrease rates, and so on), select a
negative (-) value.
For either positive or negative value,
greater absolute values will allow greater
amounts of change.
Set this to “0” if you don’t want to apply
the eect.