Roland JP-8080 - Saving RPS patterns to a card (PATTERN)

131
■ Saving RPS patterns to a card (PATTERN)
Patterns that have been recorded to internal memory can be
saved to a memory card.
Patterns can be saved in three ways: –all 48 patterns togeth-
er,” –in groups of 24,” or –individually.”
* Depending on the contents of the data, some time may
be required for the save operation to be completed when
saving either “48” or “24” items.
1 Make sure that a formatted memory card has been
inserted in the card slot.
2 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
3 Press [INIT/UTIL] (BANK [7]) several times to
access the Card display.
The [INIT/UTIL] indicator will light.
4 Use [DEC]/[INC] several times to choose “USER->CARD.”
5 Press [WRITE].
6 Use [DEC]/[INC] several times to choose “PATTERN.”
7 Press [WRITE].
8 Press [DEC]/[INC] several times to select the data
which will be saved.
If you wish to save individual RPS patterns to a memory
card, turn on ARPEGGIATOR/RPS [ON], and set
[MODE] to RPS so that you can press a key to select the
content to be saved.
ALL PATTERNS: all 48 patterns
USER C#2-C 4: 24 patterns (C#2-C 4)
USER C#4-C 6: 24 patterns (C#4-C 6)
USER C#2: the C#2 pattern
:
USER C 6: the C 6 pattern
9 Press [WRITE].
10 Use [DEC]/[INC] several times to select the save
destination.
* If in step 7 you selected ALL PATTERNS, this setting
will not appear.
11 Press [WRITE].
A confirmation will appear.
To cancel the Saving operation, press [EXIT].
12 Press [WRITE].
The display will indicate “Completed.”
The pattern data has now been saved to the card.
13 Press [EXIT] to return to the previous display.
Patterns that have been saved to a memory card can be
directly selected and used. (p.93)
■ Saving Motion Control to a card
(MOTION CONTROL)
Up to eight (four sets) of Motions that have been recorded
in internal memory can be saved on a memory card.
Motion data can be saved in three ways: “all four (2 sets)
together,” “two (1 set) together,” or “individually.”
* Depending on the contents of the data, some time may
be required for the save operation to be completed.
1 Make sure that a formatted memory card has been
inserted into the card slot.
2 Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
3 Press [INIT/UTIL] (BANK [7]) several times to
access the Card display.
The [INIT/UTIL] indicator will light.
4 Use [DEC]/[INC] several times to choose “USER->CARD.”
5 Press [WRITE].
6 Use [DEC]/[INC] several times to choose “MOTION
CONTROL.”
7 Press [WRITE].
8 Press [DEC]/[INC] several times to select the con-
tents that will be saved.
USER SET A&B: All four motions
USER SET A: The two motions of SET A
USER SET B: The two motions of SET B
USER SET A [1]: Motion [1] of SET A
USER SET A [2]: Motion [2] of SET A
USER SET B [1]: Motion [1] of SET B
USER SET B [2]: Motion [2] of SET B
9 Press [WRITE].
10 Use [DEC]/[INC] several times to select the save
destination.
Chapter
10