Need help?Do you have a question about the Rosco CSV and is the answer not in the manual?
Explains DANGER, WARNING, CAUTION, NOTICE, and NOTE symbols used throughout the manual.
Specific precautions for machine operation, hot material, and hydraulic systems.
Safety measures for refueling, battery handling, starting, stopping, parking, and operation.
Safety measures during maintenance, repair, and storage procedures.
Explains the DP710 display, control panel functions, and joystick operations.
Essential inspections before start-up and the engine starting procedure.
Explanation of driving the machine and selecting operational modes (Travel, Manual, Auto).
Details the DP710 Digital Display and how to activate control consoles.
Explains the main screen layout and how to use buttons for navigation and status icons.
Lists and describes warning icons, transducer screen, memory screen, and fault screens.
Guidance on preparing for chip spreading, aggregate selection, and operational tips.
Setting operation modes and adjusting the spread hopper width.
Information on chip sealing procedures and troubleshooting common problems.
Outlines routine and general maintenance, including periodic schedules and lubrication points.
Maintenance for engine components, fuel system, DEF system, and electrical systems.
Guidelines for storage, troubleshooting common issues, and diagnostic trouble codes.
Details 10-Hour, 50-Hour, and 100-Hour routine maintenance tasks.
Procedures for 250, 500, 1000, 2000, and 3000-hour maintenance intervals.
Identifies lubrication points and outlines procedures for planetary hubs.
To Next Page
General