Rosco CSV - Settings and Engine Screen Information

Settings Screen
This screen allows the operator to view system faults,
perform a hopper dump, extend/retract the active
operator platform or set other functions. (Figure 4-13)
1
2
3
4
5
6
7
8
9 10
Figure 4-13. Settings Screen
1 - Memory Settings
2 - Service Screens*
3 - System Faults
4 - Engine Faults
5 - Settings Screen
6 - Hopper Dump
7 - Console Active/Inactive
8 - Units
9 - Seat Slide Out
10 - Seat Slide In
Memory Settings: Pressing this button navigates to the
Memory screen. (Page 4-11)
* Service Screens: Only an authorized Rosco LeeBoy
service technician can access service screens.
System Faults: Pressing this button navigates to the
system faults screen. (Page 4-14) A red box next to the
name of the fault indicates that the fault is active.
Engine Faults: Pressing this button navigates to the
engine faults screen. (Page 4-13) A red box next to the
name of the fault indicates that the fault is active.
PSY Calibration: Pressing this button navigates to
the PSY Calibration screen where the operator can
calibrate the PSY and optimize the gates. (Page 4-14)
Hopper Dump: Press and hold this button to “dump”
aggregate from the spread hopper. This opens the
gates completely and turns on the spreadroll and
augers to clear aggregate and any debris. When the
operator releases the button, these automated functions
cease.
Console Status: Pressing this button activates and
inactivates the operator control console. (Page 4-8)
Units: Pressing this button allows the operator to set
either English or metric measurement units.
Seat Out: Press and hold this left arrow key to extend
the active operator station platform. (Figure 4-13)
Seat In: Press and hold this left arrow key to retract the
active operator station platform. (Figure 4-13)
Engine Screen
Pressing the “0” button navigates to the engine screen.
(Figure 4-14) This screen also provides the DEF tank
uid and regeneration level. (Figure 4-15)
Pressing Button 1 navigates to the System Fault screen.
Pressing Button 2 navigates to the Engine Fault screen.
Pressing Button 3 turns the work lights on and off while
Button 4 turns the beacon light on and off.
1
2
5
6
3
4
Figure 4-14. Engine Screen
1 - System Fault Screen
2 - Engine Fault Screen
3 - Work Lights On/Off
4 - Beacon Light On/Off
5 - Reverse Camera Activation
6 - Settings Screen
Operation
Rosco CSV Variable Width Chip Spreader4-12