Rosco CSV User Manual

1 2 3
Figure 5-19. DEF Tank Filter
1 - Filter Cap
2 - Filter Equalizing Element
3 - Filter Element
Follow these procedures to replace the dosing unit lter:
1. Follow Steps 1 - 4 on Page 5-16 to prepare machine
for DEF system maintenance.
2. Place a container under the DEF dosing unit as a
small amount of DEF may drain from the lines when
disconnected. (Dispose of the uid in accordance
with environmental regulations.)
3. Use a clean, damp cloth to wipe the unit to reduce
the risk of contamination entering the DEF system.
Debris can cause permanent damage and
premature failure in the DEF dosing unit.
4. Unscrew the DEF lter cap and remove the
equalizing element and lter element. (Figure 5-19)
5. Discard both the lter element and equalizing
element in accordance with environmental
regulations.
6. Reinstall the new lter and equalizing element.
7. Reinstall and tighten the cap.
NOTE: Lubrication on the DEF lter O-ring is not
required.
FUEL SYSTEM
The fuel level is indicated on the digital display
component on the control panel. Proper maintenance of
the fuel system ensures top performance and prevents
damage to internal engine components. The fuel ller
cap is located on the left side of the machine behind the
operator seat. (Figure 5-20)
Fuel
Cap
Figure 5-20. Fuel Cap Location
NOTE: Fill the tank to FULL before storing the
chip spreader overnight to reduce moisture
accumulation from condensation in the tank. Fuel
contaminated by water promotes the growth of
microbes that can clog fuel lters and lines over
time.
The operator should NEVER be on or
near the chip spreader while fuel is being added. NO
SMOKING while lling the fuel tank as all fuels for
internal combustion engines are ammable. Fill the
fuel tank only in a designated area where there is
good ventilation and a re extinguisher available.
NEVER ll the tank, check fuel level
or check for fuel leaks near an open ame or near
equipment that can create sparks.
Fuel Filter
The fuel lter element must be replaced as directed
in the Engine Operator’s Manual. The fuel lter is
located on top of the engine (Figure 5-21) and the fuel
separator is located at the left side of the frame rail
(Page 5-18).
Diesel fuel is very ammable. Use
extra caution and DO NOT spill fuel. DO NOT change
the fuel lter while the chip spreader is running. DO
NOT change the fuel lter in an area near an open
ame. DO NOT smoke while changing the fuel lter.
5
Maintenance
Rosco CSV Variable Width Chip Spreader 5-17

Rosco CSV Specifications

General

Brand	Rosco
Model	CSV
Category	Spreader
Language	English