MAINTENANCE SCHEDULE
This section gives the necessary procedures for routine
and general maintenance on the Rosco LeeBoy CSV
Variable Width Chip Spreader. Keep the spreader clean
and follow all maintenance schedules and procedures
to maintain the machine in top operating condition.
Maintenance must be a planned program including
periodic machine inspection and lubrication (see
Lubrication, Pages 5-6 to 5-8). The operator
should inspect the machine daily. Worn or damaged
parts should be replaced or repaired promptly to
prevent damage to other areas of the machine. Daily
inspections should include checking for loose bolts,
uid leaks, worn or damaged hoses, and debris or dirt
accumulations to prevent potential service or safety
problems.
The maintenance program should be done based on the
machine “Operating Hours” recorded on the hour meter
or by following the Periodic Schedule shown below:
Table 5-1. Periodic Maintenance Schedule
SYSTEM ITEM
Every
10 Hours
Every
50 Hours
Every
100 Hours
Every
250 Hours
Every
500 Hours
Every
1000 Hours
Spreader
Check conveyor belt, chute liners and wipers
alignment. Adjust if needed.
X
Adjust conveyor belt, wipers and chute liners. X
Check spread hopper seal, gates and
wearplates. Adjust if needed.
X
Adjust spread hopper seal, gates and
wearplates.
X
Adjust brakes. X
Hydraulic
Check hydraulic oil level. Add if needed. X
Replace hydraulic oil and charge lter. X
Check planetary hub gear oil. Add if needed. X
Change planetary hub gear oil. X
Check drive axle oil. Add if needed. X
Change drive axle oil. X
Engine
Check oil level - Change at initial 50 hours. X
Replace engine oil and oil lter cartridge. X
Check engine coolant. Add more if needed. X
Change engine coolant. X
Check air cleaner indicator. Clean or replace
if indicator is red.
X
Change air cleaner lter. X
Check engine drive belt. Tighten or replace if
needed.
X
Electrical
Check battery, cables and connectors. X
Service battery. X
Fuel Replace fuel lter cartridge. X
DEF
Diesel Exhaust Fluid (DEF) Tank Filter
Inspect every 2000 hours (or 2 years). Clean or
replace if needed.
DEF Supply Module Filter
Inspect every 4500 hours (or 3 years). Clean or
replace if needed.
5
Maintenance
Rosco CSV Variable Width Chip Spreader 5-3
To Next Page
Loading...