Rosco CSV - Page 47

ITEM
NO.
CONTROL NAME FUNCTION
10
Right Conveyor Manual/
Auto
Sets the right conveyor to operate either automatically or in manual mode.
11 Conveyor Speed
Sets the left conveyor speed when the conveyor is set to the manual
mode. The operator can choose from ve (5) speed options (the button will
illuminate colors accordingly): 70 RPMs (red); 105 RPMs (amber); 140 RPMs
(pink); 185 RPMs (blue); or 230 RPMs (green).
12
Individual Left Spread
Hopper Gates
Each of the eight (8) buttons controls a one-foot section of the left spread
hopper. When the machine is stationary (in manual mode), all gates that can
be used illuminate yellow. Upon chip spreading, the yellow light will turn to
green signifying that the gates are open. You can decide to shut off any of
the gates by pressing the switch to close (the light will turn red).
13
Individual Right Spread
Hopper Gates
Each of the eight (8) buttons controls a one-foot section of the right spread
hopper. When the machine is stationary (in manual mode), all gates that can
be used illuminate yellow. Upon chip spreading, the yellow light will turn to
green signifying that the gates are open. You can decide to shut off any of
the gates by pressing the switch to close (the light will turn red).
14
Left Spread Hopper
Extension
Used to move the left spread hopper extension in and out from 4 - 8 feet (1.2
- 2.4 m). Push switch to the left arrow position ({) to extend left. Push switch
to the right arrow position (}) to move in the left extension.
15
Main Left Spread Hopper
Gate
Opens and closes the left spreader hopper gate when operating in the
manual mode. To preset the gate opening, depress the button to the desired
size. The gate set-point size will show on the DP710 digital display.
16 Travel Mode
Depressing the travel mode switch backward switches the machine into
AUTO mode. In order to operate in travel mode, the hopper wings must
be retracted and the operator seats must be locked into position. If these
conditions are not met, the travel button light will blink red and the machine
will not move into travel mode. The light becomes solid green when these
conditions are met.
17
Main Right Spread Hopper
Gate
Opens and closes the right spreader hopper gate when operating in the
manual mode. To preset the gate opening, depress the button to the desired
size. The gate set-point size will show on the DP710 digital display.
18
Right Spread Hopper
Extension
Used to move the right spread hopper extension in and out from 4 - 8 feet
(1.2 - 2.4 m). Push switch to the right arrow position (}) to extend right. Push
switch to the left arrow position ({) to move in the right extension.
19 Emergency Stop
Immediately stops the machine and all electronic functions. Turn clockwise
to release the emergency stop.
20 Ignition Switch Starts and stops engine.
3
Components
3-9Rosco CSV Variable Width Chip Spreader