Settings Screen: Pressing Button 7 navigates to the
Settings screen. (Page 4-12)
Transducer Screen: Pressing the “X” button navigates
to the Transducer screen. (Page 4-11)
Engine RPMs: Press the left arrow button to decrease
engine RPMs or press the right arrow button to increase
engine RPMs.
The Main screen also displays the status of work
functions and warning status icons. (Figure 4-10,
Tables 4-2 and 4-3)
2
3
Figure 4-10. Main Screen Status Information
1 - Tachometer (Feet per Minute)
2 - PSY Rate
3 - FPM Rate
4 - Engine RPMs
5 - Active/Inactive Console
NOTE: The triangle will blink to indicate an
engine fault.
NOTE: The square
will blink to indicate a
system fault.
The following icons on the Main screen informs the
operator of the status for numerous chip spreader
functions.
Table 4-2. Main Screen Status Icons
Status
Icons
Descriptions
Memory
Displays the number of functions the
operator has set in the Memory screen.
Total Tons
Displays total tons of aggregate spread.
Total Miles
Displays the vehicle’s total mileage.
Left
Hopper
Displays the distance (in feet) the left
spread hopper is extended (up to 4 feet).
Left
Gate
Displays the number of individual gates
open on the left spread hopper main gate.
Size
Displays aggregate size.
Type
Displays aggregate type: “P” for Pit or “C”
for crushed aggregate.
Right
Gate
Displays the number of individual gates
open on the right spread hopper main
gate.
Right
Hopper
Displays the distance (in feet) the right
spread hopper is extended (up to 4 feet).
Wing
Up
Displays “Wing Up” when the receiving
hopper wings are up (hopper closed)
and “Wing Down” when hopper wings are
down (hopper open).
Auto
Displays the operational mode set : Auto,
Manual or Travel.
Conveyor
Left
Illuminates when the left conveyor is
operating.
Conveyor
Right
Illuminates when the right conveyor is
operating.
4
Operation
Rosco CSV Variable Width Chip Spreader 4-9
To Next Page
Loading...