viii
Reference Manual
00809-0100-4809, Rev DA
Title Page
September 2015
The products described in this document are NOT designed for nuclear-qualified
applications. Using non-nuclear qualified products in applications that require
nuclear-qualified hardware or products may cause inaccurate readings.
For information on Rosemount nuclear-qualified products, contact your local Emerson
™
Process Management Sales Representative.
This device is intended for use in temperature monitoring applications and should not be
used in control and safety applications.
If pipe/duct wall is less than 0.125-in. (3.2mm) use extreme caution when installing sensor.
Thin walls can deform during welding, installation, or from the weight of a cantilevered
flowmeter. These installations may require a fabricated outlet, saddle, or external
flowmeter support. Consult factory for assistance.
To Next Page
Loading...
