41
Reference Manual
00809-0100-4809, Rev DA
Section 2: Installation
September 2015
Installation
2.6.4 Threaded Flo-tap (for 485 Annubar Flowmeter)
Figure 2-27 identifies the components of the Threaded Flo-Tap assembly.
Figure 2-27. Components
Step 1: Determine the proper orientation
Refer to “Mounting” on page 8 for straight run requirements and orientation information.
Transmitter and housing are shown for clarity purposes – only supplied if ordered.
A. Transmitter
B. Coplanar flange with drain vents
C. Temperature sensor connection housing
D. Direct mount transmitter connection with valves
E. Head plate
F. Drive rods
G. Threaded pipe fitting
H. Guide nipple
I. Isolation valve
J. Cage nipple
K. Support plate
L. Packing gland
M. Packing
N. Follower
O. Compression plate
P. O-rings (2 )
To Next Page
Loading...
Need help?
General
