Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Contaminated
ATTENTION
If the oil circuit is contaminated, replace the oil cooler and flush the oil circuit.
See chapter 12–20–00 section: Flushing the oil circuit. Proper judgement re-
quires years of experience in repair of piston engines.
AE_912i_0092
2
3
1
4
5
5
from oil pump
to bearings
Figure 7.22: Oil filter
1
Filter housing
2 Filter cover
3
Gasket ring
4 Anti-drain membrane
5 Filter matt
12–20–00
Page 38
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0

Rotax 912 i series Specifications

General

Number of Cylinders	4
Max Power	100 hp (73.5 kW)
Max Power Output RPM	5800 rpm
Ignition System	Dual electronic ignition
Oil System	Dry sump, forced lubrication with separate oil tank
Reduction Gear Ratio	2.43:1
TBO	2000 hours
Engine Type	4-stroke, horizontally opposed
Displacement	1352 cm³
Bore x Stroke	84 mm x 61 mm
Max Torque	128 Nm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Fuel System	Electronic fuel injection
Cooling System	Liquid/air-cooled