Rotax 912 i series - Page 166

Effectivity: 912 i Series
Edition 2/Rev. 0
Page 54
September 01/2018
Maintenance Schedule ..........................................9
Maintenance schedule procedures .........................6
N
Non compliance — coolant specification ...............21
Non compliance — fuel quality .............................29
O
Oil change ..........................................................34
Oil filter replacement ...........................................35
Oil level check/Replenish.......................................7
Oil pressure below minimum value .......................25
Oil specification not respected..............................27
Operating hours ....................................................2
Overflow bottle....................................................28
P
Procedure notes ...................................................4
Propeller gearbox................................................52
Propeller gearbox with integrated overload clutch .. 11
Purging the oil system ..................................... 3, 42
R
Radiator cap .......................................................27
Read out the ECU data memory ...........................12
Removal of the drive gear ......................................5
Removal of the propeller gearbox ...........................2
Remove the spark plugs ......................................48
Replacement of spark plugs.................................48
Replacing the coolant ..........................................24
Replacing the dry air filter ....................................22
Replenishing operating fluids .................................1
Reporting ...........................................................32
S
Safety ................................................................10
Safety information ............................................... 11
Scheduled maintenance ........................................2
Scheduled maintenance checks ......................... 1–2
Scope of supply ....................................................4
Servicing points on the engine................................2
Smooth performance of the engine .......................30
Spark plug not in accordance with specification .....29
T
Table of amendments ............................................1
Technical documentation .....................................15
Terminology ..........................................................2
Terms...................................................................5
Test run of engine................................................15
Time limit..............................................................2
Time Limit.............................................................4
Time limit for the coolant ........................................6
Time limit, parts.....................................................5
Time limits ............................................................1
Troubleshooting ....................................................6
Type description....................................................3
U
Unscheduled maintenance checks ..................... 3, 1
Use for intended purpose.....................................17
V
Visual inspection ............................................... 5, 4
BRP-Rotax
MAINTENANCE MANUAL LINE