Rotax MMH-912 Series - Page 192

73-00-00
page 2
July 01/2008
Effectivity 912/914 Series
Edition 1 / Rev. 2
d04352
BRP-Rotax
Maintenance Manual
3.3.11) Starting carburetor (choke) ..................................................73-00-00 / 33
3.3.12) Carburetor assembly ............................................................ 73-00-00 / 33
3.3.13) Carburetor synchronization...................................................73-00-00 / 35
3.3.14) Idle speed adjustment .......................................................... 73-00-00 / 35
3.3.15) Throttle cable and linkage .....................................................73-00-00 / 35
3.4) General information on the fuel system ........................................73-00-00 / 36
3.4.1) Fuel pressure (on 912 Series) .............................................. 73-00-00 / 37
3.4.2) Fuel pressure (on 914 Series) .............................................. 73-00-00 / 39
3.4.3) Carburetor sockets and compensation tube .........................73-00-00 / 40
3.4.3.1) Carburetor sockets.................................................. 73-00-00 / 40
3.4.3.2) Compensation tube .................................................73-00-00 / 40
3.4.4) Fuel pressure regulator (only on 914 Series) .......................73-00-00 / 42
3.4.5) Fuel pump (on 912 Series) ................................................... 73-00-00 / 43
3.4.6) Fuel pump (on 914 Series) ................................................... 73-00-00 / 45
3.4.7) Pressure connecting lines (only on 914 Series).................... 73-00-00 / 47
3.5) Assembly of carburetor sockets, carburetor and fuel lines ...........73-00-00 / 51
3.5.1) Fuel pump.............................................................................73-00-00 / 51
3.5.2) Carburetors and carburetor sockets .....................................73-00-00 / 51
3.5.3) Assembly of the fuel lines (on 912 Series) ...........................73-00-00 / 53
3.5.4) Assembly of the fuel lines (on 914 Series) ...........................73-00-00 / 57
3.6) Intake manifolds fitting .................................................................73-00-00 / 59
3.7) Engaging the carburetor support ..................................................73-00-00 / 59
3.8) Connecting fuel lines (tank)...........................................................73-00-00 / 60