Rotax MMH-912 Series - 4) Treatment of corrosion and; 4.1) Propeller shaft; 4.2 Electric system

Effectivity 912/914 Series
Edition 1 / Rev. 0
71-00-00
page 15
May 01/2007
d02621
BRP-Rotax
Maintenance Manual
4) Treatment of corrosion and surface damage
In the case of long standstill times, a rust film may form on various metal parts. Severely
or heavily corroded screws, nuts, washers, bearings, bushes etc., must be replaced.
4.1) Propeller shaft
The flange should be lightly greased to prevent surface rust forming,
see 72-00-00 / sec. 3.9.10.
4.2 Electric system
See 74-00-00 / sec. 3.1.