EbV Product documentation THETA NORM/UNIT
5-9
5.1.2.5.5 Manual Summer Mode (only DHW mode)
In this program only the domestic hot water circuit remains active and the DHW
temperature is controlled according to the DHW setpoint and the DHW time program.
The heating operation is interrupted and frost protected.
Display The manual summer mode appears on the standard display: SUMMER.
NOTE The automatic programs P2 or P3 can be selected only if they were enabled in the
"System Paramete Menu - Time Program = P1-P3". If they are not enabled, only
Program P1 is active.
Setting see 5.1.2.5 key "Operating mode" (basic display)
Disable/Enable Standard Programs P2-P3
Disable
"System Parameter menu": Time program = P1
All the heating circuits as well as the hot water circuit work exclusively according to
the standard or personalized programmed switching times in time program P1. The
P1 program does not appear on the display in this operating mode.
Enable
"System Parameter menu": Time program = P1 - P3
Display The manual summer mode appears on the standard display: SUMMER. If standard
programs P2 and P3 are enabled, the relevant symbol é1, é2, or é3 is displayed.
The symbols are only displayed if time program P1 - P3 is displayed.
5.1.2.5.6 Permanent heating operation
The operating mode HEATING provides for uninterrupted heating according to the
specified daytime room temperature. The DHW heating works continuously
according to the specified DHW setpoint.
Setting see 5.1.2.5 key "Operating mode" (basic display)
NOTE The operating mode HEATING is maintained until another operating mode is
activated.
Display The heating mode appears on the standard display: HEATING.
SUMMER1
13 .15
o
c
58.0
SUMMER
13 .15
o
c
58.0
Â
HEATING
12 .00
o
c
22.0
To Next Page
Loading...
Need help?
General
