EbV Product documentation THETA NORM/UNIT
6-3
6.2.2.3 Eanbling separate operating modes and temperature changes
Description: In order to make the operation as easy as possible for most of the applications, a
common control mode is set for all heating circuits when supplied. For those rare
cases in which separate control modes are necessary (e. g. in case of separate
control mode selection for tenants and landlords) it must be enabled by means of the
"Control Mode" parameter in the "System" menu.
Effect: This parameter determines the control mode and affects the
• Operating mode selected with the operating mode key ¢
¢¢
¢
• Daytime temperature selected with the temperature selection key ¥
¥¥
¥
• Night-time temperature selected with the temperature selection key ¦
¦¦
¦
concerning the effect on the different heating circuits.
6.2.2.4 Selection of Hydraulic Parameter Presettings (..F..)
Description: Each controller type, when supplied, covers a specific hydraulic diagram (see
overview on page 1). Depending on the configuration variants there is also the
possibility of adapting the system by means of further parameter settings to hydraulic
systems differing from the standard hydraulic system.
Parameter 01 in the "Hydraulic" menu enables a preselection in the hydraulic
schemes collection. The corresponding inputs and outputs are assigned
automatically according to the hydraulic diagram and can be altered if necessary.
Operation:
Note on operation Key / parameter tree Parameter
Effect on operating mode selection
¢
Effect on daytime temperature
selection
¥
Effect on night-time temperature
selection
¦
Enabling separate settings SYSTEM CONTROL MODE
Operation:
Note on operation Key / parameter tree Parameter
Hydraulic preselection HYDRAULIC PARAMETER 01
To Next Page
Loading...
Need help?
General
