Rotex Controller Series - Emission Measurement; Manual Mode Key

EbV Product documentation THETA NORM/UNIT
5-15
Automatic return
If the "information key" ¤ is pressed for approx. 3 s upon accessing the information
level, the INFO TIME parameter appears.
This parameter determines the time for the automatic return to the standard display.
Factory preset: OFF
Setting range OFF, 1...10 min
OFF No exit, the last information displayed remains
until the next setting on the display.
Note: Malfunction messages
1...10min Automatic exit from the information level after
the specified time, settable in 0.5 minute steps.
5.1.2.8 "Emission Measurement / Manual Mode" Key
5.1.2.8.1 Emission Measurement (may only be carried out by the heating specialist).
CAUTION Emission Measurement has to be carried out by a technician.
By pressing this key, the heat generator runs for 20 minutes at the set maximum
temperature limit. The remaining time is displayed as it passes.
Both stages of two-stage heat generators are in operation (measurement with
nominal capacity).
CAUTION Danger of scalding because the DHW temperature may exceed the defined
DHW setpoint.
Function: The heat generator is adjusted to the maximum H-GEN temperature. All heating
circuits and DHW heating adjust their nominal value to the corresponding maximum
temperature.
Application: Emission measurement by the technician
Termination: The emission measurement can be terminated prematurely at any moment using the
¡ key.
INFO TIME
OFF
¡