EbV Product documentation THETA NORM/UNIT
5-34
5.4.4.3.2 Separate Control Mode Nighttime Temperature
Function:
In this operating mode, the relevant setpoint applies only to the selected HC (=
unmixed circuit), MC 1 (= mixed circuit 1) or MC 2 (= mixed circuit 2)
Setting:
•Press ¦ key
• Select the desired heating circuit, HC, MC-1 or MC-2, using the rotary pushbutton
• Confirm the selected circuit by pressing the rotary pushbutton
• Set the flashing room temperature value by turning the rotary pushbutton to the
desired value.
• Confirm set value by pressing ¦ or î , press again: return to standard
display
• Alternatively the value can be confirmed by automatic exit after the set time.
5.4.4.3.3 Separate Control Mode Operating Mode Selection
Function:
In separate operating mode, the selected program only applies to the previously
specified heating circuit.
Hence each heating circuit can be assigned its own operating mode.
Setting:
•Press ¢ key
• Select the desired heating circuit, HC, MC-1, MC-2 or DHW using the rotary
pushbutton
• Confirm the selected circuit by pressing the rotary pushbutton
• Set the flashing operating mode by turning the rotary pushbutton to the desired
value.
• Confirm set value by pressing ¢ or î.
• In short-term operating modes (Holiday, Absence, Party) set the desired target
value by turning the rotary pushbutton and confirm the set value as described
above.
• Alternatively the value can be confirmed by automatic exit after the set time.
¦
ROOM NIGHT
HC
16.0
o
c
OP. MODE
MC1
AUTOMATIC
MC1
To Next Page
Loading...
Need help?
General
