EasyManuals Logo

Rotex GW-30 C22 User Manual

Rotex GW-30 C22
Go to English
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
18
5.2 Connecting DHW installation
1. Rinse the installation carefully.
2. If required, assemble an inlet combination.
3. Assemble the cold (D) and warm water pipe (D) to the connection set.
Comments
If the unit is only used for warm water supply, the heating function can be switched
off using the service code on the operating panel. The CH installation does not need
to be connected or filled.
If the unit is switched off during winter, and is disconnected from the electricity
supply, the sanitary water must be drained in order to prevent freezing. To do so,
disconnect the tap water connections straight underneath the unit.
In case of old installations or domestic hot water circuits which can contain small particles,
install a filter in the domestic hot water circuit.
This pollution could cause a fault during domestic hot water operation.
Resistance graph tap circuit unit
A. RKOMBG22AAV1
B. RKOMBG28AAV1
C. RKOMBG33AAV1
X. Water pipe pressure (Bar)
Y. Flow rate (L/min, tolerance ± 10%)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotex GW-30 C22 and is the answer not in the manual?

Rotex GW-30 C22 Specifications

General IconGeneral
BrandRotex
ModelGW-30 C22
CategoryBoiler
LanguageEnglish

Related product manuals