Royal 240DX - Setting the Machine Number

31
Royal 240DX User’s Guide
After you program a Password, you must use it every time you go to the program
mode or to go to X or Z report modes, depending on which you set the Password for.
When you enter a Password, it appears as asterisks **** on the displays for extra
security.
To set manager Passwords (also known as Universal Passwords)
PROGRAM SETTING CLERK SETTING  Manager Setting
1 Press the SUB/ESC key.
2 Press the Arrow Down key to select PROGRAM SETTING. Press the
CASH/Enter key.
3 Press the Arrow Down key to select CLERK SETTING. Press the
CASH/Enter key.
4 Press the Arrow Down key to select Manager Setting. Press the
CASH/Enter key.
5 Press the Arrow Down key to select Password. Press the
CASH/Enter key.
6 Follow the instructions on the display.
To use the manager Password
Example 3: Go to the Z mode, using the Manager Password 1313
1 Press the press the SUB/ESC key.
2 Press the Arrow Down key to select Z REPORT. Press the CASH/Enter
key.
3 Using the round Number keys, press 1313 and then press the CASH/Enter
key.
4 You are now ready to run Z reports.
Setting the Machine Number
You can assign your cash register its own number. This is useful if you have
several cash registers and want to track which one creates which receipts and
transactions.
The machine number prints on all receipts/journal records, and management
reports. The machine number can be up to 4 digits long.
After you are done PROGRAM SETTING the machine number, you can check
your results. See Printing the Program Confirmation Report on page 43.
To set the machine number
PROGRAM SETTING SYSTEM PARAMETER  System Configuration
 Machine No.