Main functions
86
Ocean 2014 User's Manual
2014-06-02/3.2A
The most frequently used settings are the sensitivity adjustments, and these are shown first. If you want
to see more settings for the internal detector, click on "More". If you often use the extended settings
you may want to have it expanded all the time. You can do this in Program options -> Meter
preferences. Check the box "Always show extended meter settings".
The meter settings you see on the meter tabs to the right are valid for the active row in the grid only.
Each row can have its own settings that may be different from the rows above or below it.
The meter settings are saved in the template and will be remembered the next time you repeat the
same measurement using the same template.
If you want to apply the same meter settings to several rows, you can do it by following the steps
below:
1. Use "multi-select" to select the rows you want the meter settings to apply to. Use Shift+click and Ctrl
+click to select multiple rows.
a) To select a range of rows: click on the first row you want to have in your selection.
b) Hold down Shift and click on the last row you want to include in your selection.
To Next Page
Loading...
Need help?
General
