Russound MCA-C3 - Table of Contents

MCA-C3 Test Procedure
Page 2 of 77
Contents
1. Inspection Page 3
2. Equipment Needed
Page 3
3. Install Wake On LAN GUI
Page 4
4. Install Russound USB Driver
Page 5
5. Install RNET Version Reader v1.01.02
Page 10
6. Install RVCLI Scripter
Page 11
7. Install & Setup FDT 4.01
Page 13
8. Install Russound SCS-C5
Page 18
9. Load MAC ID to U38 (94LC46B-I/SN)
Page 20
10. Program BootLoader
Page 21
11. Russound Device Update
Page 24
12. Tuner MCU Firmware
Page 25
Note: Russound Personnel Start here if it is known the CM
has installed the latest firmware.
13. Signal Generator Test Fixture Page 28
14. Initial Test Setup
Page 29
15. 240V AC Test Page 35
16. 110V AC Test
Page 36
17. Ethernet LED
Page 36
18. Serial Interface RS232
Page 37
19. RS485 Test of Link Ports
Page 38
20. AM/FM Tuner
Page 39
21. Controller ID Switch
Page 44
22. IP Address
Page 45
23. MAC Address / Ethernet Port
Page 46
24. Enable Sources
Page 46
25. Bass All Zones
Page 47
26. Zone 1
Page 49
27. Zone 2 – 6
Page 54
28. Zone IR
Page 55
29. Zone Paging
Page 56
30. Audio and Page Sense
Page 58
31. Triggers
Page 60
32. Front Panel LED
Page 63
33. Page_In_IRQ
Page 64
34. HT_In_IRQ
Page 65
35. RTC_IRQ
Page 66
36. WOL_IRQ
Page 67
37. UEI
Page 69
38. Factory Initialization
Page 70
39. Factory Settings prior to Shipping
Page 71
40. Appendix
Page 71
41. Firmware Upgrade with bootloader installed
Page 76
42. Revision History
Page 76
Note: Changes to Revisions are listed on the last
pages of the procedure.