MCA-C3 Test Procedure
Page 3 of 77
Inspection
Russound customers expect the best; defects are unacceptable. Inspect the Unit
Under Test visually for any blemishes, missing pieces and visual indications that
may cause concern. Passing visual inspection is a condition of passing full test.
Correct any defect before passing the Unit Under Test; if Unit Under Test has
defects that cannot be corrected, notify your supervisor. Inspect the Unit Under
Test before and after functional testing. Inspect the Gift Box and its contents
comparing it to the list on the outside of the box.
Equipment Needed
1. (1) IBM PC with Windows XP SP2 with
DVD player
2 Gigs of RAM
Com port (9 Pin serial)
Ethernet Port
Sound Card
2. (1) RS232 cable (9 Pin)
3. (11) 6’ or longer RJ45 patch cords
4. (18) 6’ or longer quality RCA Audio cable color coded
Red and White
5. (1) Pair of 8 Ohm 20W minimum speakers
6. (2) Dual Channel Oscilloscope with 20Mhz bandwidth minimum
(Tektronix TPS2012 or equivalent)
7. (1) 4 Port Switch for Ethernet Port of the IBM PC
8. (16) 6’ or more cable with 3.5mm mono plug on each end
9. (1) USB A-to-B cable
Russound Supplies items needed below
10. (1) Flash Development Toolkit 4.01
11. (1) Russound IR Switcher PCB (Russound Design)
12. (1) RCK Keypad, RNET Control Keypad (Russound Design)
13. (2) RSS, Russound Source Selector (Russound Design)
14. (1) Speaker Selector (Russound Design)
15. (1) Speaker Output isolation fixture (Russound Design)
16. (1) Signal Generator Test Fixture (Russound Design)
17. (1) RVCLIScripter latest version
18. (1) RNET Version Reader v1.01.02
19. (1) Russound Device Update
20. (6) MDK-C3 Keypads
21. (1) SRC2 Remote Control
22. (6) Russound 1201A power pack (For RSS, RCK, SGTF, and Speaker Selector)
(1201A is a 12V 1.0A positive tip power pack)
23. (1) Russound SRM-2.1
To Next Page
Loading...
