For experienced Users: AT commands
SAGEM RT3000 63
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Command Function (factory setting in bold print)
(dialling digits): 0-9, * , #, +, A, B, C
; Only required to set up voice calls. The device remains in
command mode.
x =: i Activates CLIR (disables presentation of own phone
number to called party)
I Deactivates CLIR
ATE[n]
Command echo
Parameters:
n = 0: Echo mode off
1: Echo mode on
ATH[n]
Hang up
Parameters:
n= 0: Terminate call
ATI[n]
Output product code
0 ‘RT-3000 DNT8115’
3 ‘Firmware Version: 1.004’
4 ‘GSM-Module-Firmware: SAGEM JE3,7D’
8 Output supported operating modes (see ATB)
9 Identification of the modem and the mobile phone
ATQ[n]
Specifies whether or not the device transmits any result code to
the connected TE. Information text transmitted in response is not
affected by this setting.
Parameters:
n = 0: result codes transmitted by TA
1: no result code transmitted by TA
ATS0=n
Writes value n into status register 0
.
Set number of rings before
automatically answer the call. This command is valid only for
data calls.
Parameters:
n = 0: automatic answering deactivated
1-255: number of rings before automatically answering
ATS0? Displays the value of status register 0
ATS3=n
Writes the value n into status register 3
.
This parameter
determines the character recognised by TA to terminate an
incoming command line (13 = <CR> by default)
Parameters:
n= 0 – 127 : command line termination character
ATS3? Displays the value of status register 3
ATS5=x
Writes the value
x
into status register 5. Determines the
command line editing character.
Parameters:
To Next Page
Loading...