112 • Program Mode SAM4S ER-230EJ Manual
PLU STOCK
Note: Before program PLU stock, ‘Inventory Item’ option set as ‘Y’ in PLU
programming.
1. From the PLU PROGRAMMING screen, press3 and CASH to display the
PLU STOCK screen:
PLU STOCK
1. ONE
2. RANGE
2. Select the PLU or PLUs you wish to program one of the following ways.
ONE PLU
3. From the PLU STOCK screen, press 1 and CASH to add an individual PLU.
The PLU NUMBER screen display:
ENTER PLU #
0
RANGE PLU
3. From the PROGRAM screen, press 2 and CASH to display RANGE PLU
screen.
ENTER FROM PLU #
0
4. Enter FROM PLU# number and CASH to display TO PLU# screen:
ENTER FROM PLU#
1
ENTER TO PLU#
20
5. Enter TO PLU# number and CASH to display STOCK ENTRY screen:
OPERATOR: ADD(+)
ADD(+)
6. Select operator ADD(+), SUB(-) or REPLACE.
7. Enter the stock quantity you wish to ADD/SUBTRACT/REPLACE, and press
CASH. Note that stock is kept in decimal units and you must enter new or
additional stock to two digits beyond the decimal. For example, type 1 0 0 0 to
enter ten units of inventory.
8. To program a additional PLUs repeat step 3 or press CLEAR key to finalize.
To Next Page
Loading...
