Sam4s ER-230EJ - Not Found PLU; Quick Entry Method; Full Entry Method

SAM4S ER-230EJ Manual Operations • 59
Not Found PLU
Note: The “SYSTEM” of "Options Programming" in the "Program Mode " chapter.
“ENABLE NOT FOUND PLU” must be set to YES to allow this function.
The “Not Found PLU” feature is available for use when an optional scanner is used to
input PLUs. If an item is scanned that is not programmed in the PLU file, the operator has
the option to input the price of the item and assign it the same descriptor and properties of
another PLU. This provides a simple mechanism for quickly building an item file for a
simple scanning installation.
Quick Entry Method
1. Scan an item or input a PLU number. If the item is in the PLU file, it will
register, if an item is not in the PLU file, the NOT FOUND PLU screen will
display:
NOT FOUND PLU
0
2. Enter the PLU PRICE. Press PLU on the keyboard. The screen will be display:
PLU1
1 100.00
Note: The not found PLU will assume the same attributes of the PLU selected here. For
example, if the item scanned is a “liquor” item, then press another PLU in the liquor
category, or if you are using a PLU designated to accept open liquor entries, that PLU
must be set to be a preset PLU with a preset value of zero and preset override allowed.
(If you copy the PLU to an open PLU, the not found PLU will also be an open PLU.).
Full Entry Method
3. Scan an item or input a PLU number. If the item is in the PLU file, it will
register, if an item is not in the PLU file, the NOT FOUND PLU screen will
display:
NOT FOUND PLU
ENTER CASH KEY
4. Press CASH key to creast PLU. The screen will be display:
NOT FOUND PLU
1.DESC: [ ]