Sam4s ER-230EJ - Macro Key Programming

SAM4S ER-230EJ Manual Program Mode • 131
Macro Key Programming
Macro keys may be programmed to record, and then later perform, up to 50 keystrokes.
For example, a macro key could be set to tender (preset tender) a common currency, such
as £5 into the CASH key. Use this program to record keystrokes for each of the 10 possible
macro keys.
To Program a Macro
1. From the PROGRAM MODE, press 3 and CASH for FUNCTION KEY. The
FUNCTION KEY PROGRAM screen displays:
FUNCTION KEY
1. FUNCTION KEY
2. From the FUNCTION KEY screen, press 2 and CASH for MACRO. The
MACRO PROGRAM screen displays:
ENTER MACRO KEY
TO BE PROGRAMMED
3. Press the macro key (MACRO1 – MACRO10) that you wish to program.
The screen diplays Macro descriptor. Press the CASH key to make macro line.
MACRO1
MACRO1
4. The screens displays the first macro line:
MACRO1
1:
5. Press the first key of the macro sequence, Type up to 50 key stokes. For
example, press 5 (numeric five): and CASH.
MACRO1
2: CASH
6. Press the same MACRO key to end the sequence.
7. Continue to program additional MACRO key sequence or press CLEAR key
to return to PROGRAM MODE screen.
To Remove a Macro
If you wish to remove a key stroke from a macro, replace the current function with
the INACTIVE function.
NOTE: PAGE↑ , PAGE↓ , ↑ , ↓ keys are to move menu to menu in X, Z, P, S mode
so the Macro Key need to be other places than those(PAGE↑ ,PAGE↓ ,↑ ,↓ ).