SECTION III USE
Front P.T.O. (1000 rpm)
On request, the tractor can be equipped with a front PTO driven directly
from the engine crankshaft via a gearbox and electro-hydraulically
operated clutch capable of transmitting full engine power.
The front PTO operates
independently of the rear PTO.
To engage the front PTO, use the
switch to the right of the driving
position.
Push the switch forwards to
engage the front PTO and back to
disengage it.
The switch also has a middle
position in which the PTO is
disengaged and the engine can be
started.
The switch is fitted with a lock
device to prevent accidental
engagement and disengagement
of the PTO.
To engage or disengage the PTO,
hold down the release button on
the driver end of the switch and
move the PTO switch forward or
back.
40
DANGER: AS SOON AS THE CARDAN SHAFT (SHAFT WITH UNIVER-
SAL JOINT(S)) IS REMOVED, ALWAYS INSTALL THE PTO OUTPUT
SHAFT CUP.
DANGER: DO NOT CONNECT, DISCONNECT OR ADJUST PTO WITH
THE ENGINE RUNNING.
CAUTION: AFTER ANY P.T.O. OPERATION, ENSURE THAT THE P.T.O.
CLUTCH LEVER (OR PUSH BUTTON) IS DESENGAGED; THEN PUT
IN “NEUTRAL” THE P.T.O. RPM SELECTOR DEVICE (540/1000, ECO,
GROUND SPEED; IT’S DEPENDING FROM TRACTOR CONFIGURA-
TION).